EasyManuals Logo

Omron NT31 User Manual

Omron NT31
707 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #184 background imageLoading...
Page #184 background image
173
Transmitting the Screen Data
Section 6-6
Precautions to Be Observed When Transmitting Screen Data
If any of the following, or a system error, occurs during transmission of screen
data, the transmitted screen data will not be registered correctly in the
NT31/NT31C. If this happens, the NT31/NT31C may not enter the RUN mode
when started up, or there may be unpredictable malfunctions such as failure to
display screens during operation. In this case, the screen data must be retrans-
mitted in file units to register it correctly.
S The power to the NT31/NT31C is interrupted or the NT31/NT31C is reset.
S The power to the personal computer on which the Support Tool is running is in-
terrupted or the computer is reset.
S The cable connecting the NT31/NT31C to the personal computer on which the
Support Tool is running is disconnected or has a broken wire.
S The “Quit” touch switch on the NT31/NT31C screen is pressed to end screen
data transmission.
S Screen data transmission is stopped by operation at the Support Tool.
Note When transferring the data in units of screens, if there are changes in memory
table and/or direct access, transfer such data along with the screen data.

Table of Contents

Other manuals for Omron NT31

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron NT31 and is the answer not in the manual?

Omron NT31 Specifications

General IconGeneral
BrandOmron
ModelNT31
CategoryTouch terminals
LanguageEnglish

Related product manuals