53
Using a Memory Unit (NT31/NT31C with V1)
Section 3-5
Reading and Writing Data by Manual Transmission
In this method, the direction of transmission and area of the memory unit used are
set by touch switch operations at the NT31/NT31C. Transmission can be execut-
ed while checking the settings.
Reference: When data is written to the NT31/NT31C or memory unit, the data that has been
stored up until that point is lost.
S Method of execution
Use the following procedure to write screen data using manual transmission.
(1) Check that the NT31/NT31C power is OFF, then set the DIP switches on the
memory unit as follows.
SW1
SW2
Setting of SW1-4 not relevant
Setting of SW2-3 not relevant
Setting of SW2-4 not relevant
In order to avoid loss of data in the event of misoperation, it is advisable to
set SW2-1 and SW2-2 so as to disable writing to the unit from which the data
is to be read.
(2) Switch the NT31/NT31C power ON.
Display language select screen appears.
(3) Press the “Japanese” or “English” touch switches to select the display lan-
guage.
The following descriptions are for when “English” is selected.
The screen shown below is displayed.
To Next Page
Loading...
