Omron NX Series Reference Manual

A - 5
Appendices
NX-series Data Reference Manual (W525)
A-2 NX Units That Have Restrictions in
Communications Cycles
A
A-2-1 NX Units That Have Restrictions in Communications Cycles in DC Mode
A-2 NX Units That Have Restrictions in
Communications Cycles
This section describes the NX Units that have restrictions in the communications cycles in DC Mode
and Free-Run Mode for EtherCAT Slave Terminals that you can set.
The following table gives the NX Units that have restrictions in the communications cycles in DC Mode
for EtherCAT Slave Terminals that you can set. For information on the communications cycles that you
can set, refer to Refresh Cycles in the user's manuals for the NX Units.
The following table gives the NX Units that have restrictions in the communications cycles in Free-Run
Mode for EtherCAT Slave Terminals that you can set. For information on the communications cycles
that you can set, refer to Refresh Cycles in the user's manuals for the NX Units.
A-2-1 NX Units That Have Restrictions in Communications Cycles in
DC Mode
NX Units User's Manual
Position Interface Units NX-series Position Interface Units User's Manual
(Cat. No. W524-E1-06 or later)
Load Cell Input Unit NX-series Load Cell Input Unit User's Manual (Cat. No.
W565)
A-2-2 NX Units That Have Restrictions in Communications Cycles in
Free-Run Mode
NX Units User's Manual
Position Interface Units NX-series Position Interface Units User's Manual
(Cat. No. W524-E1-06 or later)

Omron NX Series Specifications

General

Brand	Omron
Model	NX Series
Category	Controller
Language	English