Omron NX1P2 series User Manual

6 Troubleshooting
6 - 48
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)
Event name Incorrect SD Memory Card Removal Event code 10310000 hex
Meaning SD Memory Card removal processing failed.
Source PLC Function Module Source details None Detection
timing
At SD Memory
Card removal
Error attributes Level Observation Recovery --- Log category System
Effects User program Continues. Operation Not affected.
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
The SD Memory Card was removed
while the SD PWR indicator was lit.
Check the files on the SD Memory
Card to see if they are correct. If the
files on the SD Memory Card are not
correct, download the correct files to
the SD Memory Card.
Press the SD Memory Card power
supply switch and confirm that the SD
PWR indicator goes out before you
remove the SD Memory Card.
Attached
information
None
Precautions/
Remarks
None

Omron NX1P2 series Specifications

General

Model	NX1P2 Series
Manufacturer	Omron
Type	Controller
CPU Units	1
Program Capacity	5 MB
Data Memory Capacity	128 KB
Ethernet Ports	1
Serial Ports	1
Built-in EtherNet/IP Port	Yes
Built-in EtherCAT Port	Yes
Built-in USB Port	Yes
SD Memory Card Slot	Yes
USB Port	1
Power Supply Voltage	24 VDC
Programming Language	Ladder, Structured Text, Function Block Diagram
Communication Protocols	EtherNet/IP, EtherCAT, Serial (RS-232C)