Omron Sysmac NX-PD1000 User Manual

4-1-2
Attaching Markers
You can attach markers to the NX Units to identify them.
The plastic markers made by OMRON are installed for the factory setting. The ID information can be
written on them.
Commercially available markers can also be installed.
Replace the markers made by OMRON if you use commercially available markers now
.
A marker that is attached
to the NX Unit
A marker that is attached
to the terminal block
The marker attachment locations vary depending on the type of the external connection terminals on
the NX Units.
Refer to the user’
s manual for the NX Units that you use for the external connection terminals.
External connection terminals on NX Units Marker attachment location
Screwless clamping terminal block NX Unit and terminal block
M3 screw terminal block
MIL connector NX Unit only
Fujitsu/OTAX connector
Marker Installation Method
Insert the protrusions on the markers into the marker attachment locations.
Marker attachment
location
Marker
Screwless clamping
terminal block
NX Unit
M3 screw
terminal block
Marker attachment
location
Marker Marker
Terminal
block cover
Marker attachment
location
4 Installation and Wiring
4-5
NX-series System Units User's Manual (W523)
4-1 Installing NX Units
4
4-1-2 Attaching Markers

Omron Sysmac NX-PD1000 Specifications

General

Brand	Omron
Model	Sysmac NX-PD1000
Category	Controller
Language	English