Omron Sysmac NX-PD1000 User Manual

NX Unit Corresponding unit versions/versions
Model Unit version
EtherCAT Coupler
Unit
CPU Unit or Indus-
trial PC
Sysmac Studio
NX-PD1000 Ver.1.0 Ver.1.0 Ver.1.05 Ver.1.06
NX-PF0630
NX-PF0730 Ver.1.08
NX-PC0020 Ver.1.06
NX-PC0010
NX-PC0030
NX-TBX01
A-6-2
Connection to an EtherNet/IP Coupler Unit
This section describes the relationship between the unit versions of each Unit, EtherNet/IP Coupler
Unit, CPU Unit and Industrial PC, versions of the Sysmac Studio and NX-IO Configurator
, and the
specification changes for each unit version.
Relationship between Unit Versions of Units
The items that are used in the version combination table are given below.
NX Unit Corresponding unit versions/versions
Model Unit version
Application with an NJ/NX/NY-series
Controller
Application with a CS/CJ/CP-series PLC
EtherNet/IP
Coupler
Unit
CPU Unit or
Industrial
PC
Sysmac
Studio
EtherNet/IP
Coupler
Unit
Sysmac
Studio
NX-IO Con-
figurator
Model num-
ber of NX
Unit.
Unit version
of the NX
Unit.
Unit version
of
EtherNet/IP
Coupler Unit
that is com-
patible with
the NX Unit.
Unit version
of NJ/NX-
series CPU
Unit or NY-
series Indus-
trial PC that
is compatible
with the
EtherNet/IP
Coupler Unit.
Sysmac Stu-
dio version
that is com-
patible with
the NX Unit,
EtherNet/IP
Coupler Unit,
CPU Unit,
and Industri-
al PC.
Unit version
of
EtherNet/IP
Coupler Unit
that is com-
patible with
the NX Unit.
Sysmac Stu-
dio version
that is com-
patible with
the NX Unit,
EtherNet/IP
Coupler Unit,
and CPU
Unit.
NX-IO Con-
figurator ver-
sion that is
compatible
with the NX
Unit, Ether-
Net/IP Cou-
pler Unit, and
CPU Unit.
The version combination table is given below.
• With the combinations of the unit versions/versions shown below
, you can use the functions that are
supported by the unit version of the Unit model. Use the unit versions/versions (or the later/higher
unit versions/versions) that correspond to the NX Unit models and the unit versions. You cannot use
the specifications that were added or changed for the relevant NX Unit models and the unit versions
unless you use the corresponding unit versions/versions.
• Depending on the type and model of the Unit to which the NX Unit is connected, some Units do not
have the corresponding versions given in the table. If a Unit does not have the specified version,
support is provided by the oldest available version after the specified version. Refer to the user’s
manuals for the specific Units for the relation between models and versions.
Appendices
A-32
NX-series System Units User's Manual (W523)

Omron Sysmac NX-PD1000 Specifications

General

Brand	Omron
Model	Sysmac NX-PD1000
Category	Controller
Language	English