Omron V600 Series User Manual

121
RFID System
Operation Manual
Section 5 Communications Commands
Section 5
Communications
■ 1:N Communications
Write Command information is cleared under the following conditions.
If the ID Controller's power supply is reset
A command input error will occur if WRITE REPEAT is executed under this condition.
Command code The command code of the most recently executed Write Command.
End code Indicates the results of command execution.
00: Normal end
Refer to End Codes for more information.
p.135
Command
Command code
RP
2
2
*CR
Terminator
2
xx
FCS
3
Controller No.
x
@ x
Response
Command code
xx
00
22
2
*CR
Terminator
End code
2
xx
FCS
3
Controller No.
x
@ x

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C