Omron V600 Series - General Communications Subcommands

122
Section 5 General Communications Subcommands
RFID System
Operation Manual
Section 5
Communications
General Communications Subcommands
These commands are used in combination with a Communications Command and cannot be used alone to
execute communications with Data Carriers.
COMMAND PROCESSING TERMINATE (AA)
COMMAND PROCESSING TERMINATE is used to cancel command processing and return to
Command Wait Status for any command except for Polling Commands. Communications divided into
frames for Expansion Command can also be canceled.
■ 1:1 Communications
End code Indicates the results of command execution.
14: Auto or Normal Command processing has not been executed.
75: Processing was canceled before a Data Carrier was detected.
76: Processing was canceled during read/write processing with a Data Carrier.
Refer to End Codes for more information.
p.135
Command
Command code
AA
2
2
*CR
Terminator
Response
Command code
AA
xx
22
2
*CR
Terminator
End code