Omron V600 Series User Manual

5
RFID System
Operation Manual
Preface
Preface
The V600-CA5D01 and V600-CA5D02 complies with the following standards.
1.U.S.A., Canada (UL Standards)
UL (Underwriters Laboratories Inc.) conditions have been met.
UL508
Use the product connected to one of the following two circuits.
(1) Limited Voltage/Current Circuit (Approved in UL508)
A circuit that uses as its power supply the secondary coil of an insulated transformer that satisfies the
following conditions:
 Maximum voltage (with no-load): 30 Vrms (42.4 V peak)
OR
 Maximum current: (1) 8 A (including when shorted) OR
(2) A current restricted by a circuit protective device (e.g., fuse) with the following
ratings
(2) A circuit with a maximum voltage of 30 Vrms (42.4 V peak) that uses as its power supply a Class 2
power supply defined in UL1310 or a Class 2 transformer defined in UL1585
2. Europe (EMC Standards)
The requirements of the EC Directive have been satisfied.
EMC Standards EN 61000-6-2
EN 61000-6-4
Regulations and Standards
No-load voltage (V peak) Maximum current rating (A)
0 to 20 5.0
Over 20 to 30
100
peak voltage

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C