Onicon F-1000 SERIES - Updating the Configuration Utility

F
-
1000 SERIES TURBINE METER CONFIGURATION UTILITY AND INSTALLATION GUIDE
ONICON Incorporated 727.447.6140 Page 5 onicon.com
You will now have an ONICON “Smart Turbine Meter” Icon on your
desktop which can be used to quickly open the utility. You can also
locate the conguration utility in the le location specied during
the installation process as shown in the installation sequence.
6. Click “Finish” to close the installation wizard.
1.3 UPDATING THE
CONFIGURATION UTILITY
If at any point you wish to update the Conguration Utility to a newer version,
please use the following process.
1. Acquire the newest version of the software from ONICON - https://www.
onicon.com/products/f1000-series-turbine-ow-meters.
2. Uninstall any current versions of the Conguration Utility from your
computer. Use your computer’s Add/Remove Programs feature in the
Control Panel to remove the Congurator.
The software will be listed with the name “SmartTurbineMeter” and
Publisher “ONICON” in the program list.
3. Install the Conguration Utility per the procedure in the “Installing the
Conguration Utility” section above.