Onicon F-1000 SERIES - 2 Usb Cable and Driver Installation; Driver Installation

F
-
1000 SERIES TURBINE METER CONFIGURATION UTILITY AND INSTALLATION GUIDE
ONICON Incorporated 727.447.6140 Page 6 onicon.com
At the end of the attempt to automatically install the driver, you will receive
either a “Successful” or “Unsuccessful” message. If you received a “Successful”
installation, you are ready to proceed to the next section of the manual, “How to
Use the Conguration Utility.”
If the automatic driver installation was “Unsuccessful”, the steps below outline the
procedure to manually install the driver for the turbine meter.
Open your Control Panel and access the Device Manager. Once in the Device
Manager, open the “Other devices” tree, right-click on the “Turbine Meter,” and
select “Update Driver Software…”:
SECTION 2.0.
DRIVER INSTALLATION AND USB CABLE
2.1 DRIVER INSTALLATION
In the “Update Driver Software” screen, click “Browse…” and select the folder for
the Conguration Tool which was provided by ONICON. Make sure the “Include
Subfolder” check box is enabled and click “Next”.
Driver Location
Selection
Once the location of the driver is specied, it will install. You will likely be asked
by Windows Security to accept the installation, which you must do in order to
proceed. Once the driver installation is complete, there will no longer be an error
under the Turbine Meter Device in the Device Manager: