Onicon F-1000 SERIES - Programming;Informational Tabs; Meter Data

F
-
1000 SERIES TURBINE METER CONFIGURATION UTILITY AND INSTALLATION GUIDE
ONICON Incorporated 727.447.6140 Page 11 onicon.com
3.3 PROGRAMMING/
INFORMATIONAL TABS
The various diagnostic information and conguration options available with the
Congurator Utility are separated into dierent sections called tabs. Each tab has
a dierent purpose. For example, the “Pipe Selection” tab allows the user to set
the pipe size and material that the meter’s output is congured for. The “Real-
time Data” tab allows the user to see the current status of the turbine rotation as
well as the output signals.
Each tab and the information available within each tab are discussed in the
following sections.
3.3.1 METER DATA
The meter data tab provides general information about the meter like its
serial number, manufactured/calibrated date, meter type, and date it was last
programmed.
Meter Data Tab
Serial Number (Read Only)
The serial number of the meter is a unique identier. When contacting ONICON
for support or additional questions regarding a meter, please be ready to provide
this serial number. If your meter shipped calibrated to a specic pipe size and
output range, ONICON can retrieve this original calibration data with the help of
the serial number.
Manufacture Date (Read Only)
The date that your meter was manufactured at ONICON. This date may not match
the calibration date if the meter has been returned to ONICON for recalibration
service after the original manufacture date.
Calibration Date (Read Only)
Date that your meter was last calibrated at ONICON. This date may not match
the manufacture date if the meter has been returned to ONICON for recalibration
service after the original manufacture date.