Onicon F-1000 SERIES - Pipe Selection

F
-
1000 SERIES TURBINE METER CONFIGURATION UTILITY AND INSTALLATION GUIDE
ONICON Incorporated 727.447.6140 Page 13 onicon.com
Program Date (Read Only)
This is the date the meter was last modied via the Conguration Utility.
3.3.2 PIPE SELECTION
The pipe selection tab provides the means to modify the pipe size and material
the output of the turbine meter will be scaled to.
The accuracy of the volumetric output, whether it is volume rate (4-20mA)
or volume total (scaled pulse), is dependent on an accurate pipe ID being
programmed in the meter:
Volumetric Flow Output=Average Velocity x Internal Pipe Area
Pipe Selection Tab
Meter Type (Read Only)
The meter type denes the number of turbines and whether your meter is an
insertion/inline type.
• F-1100 – Single Turbine Insertion Flow Meter
• F-1200 – Dual Turbine Insertion Flow Meter
• F-1101 and F-1134 – Single Turbine Inline Flow Meter
The number of turbines and the body type directly aect the calibration, and
whether the pipe data needs to be entered. For these reasons, the meter type is
set at the factory and is read-only.
If “F-1101 and F-1134” is the meter type, then there will be no further information
within the Pipe Selection tab.