Onkyo TX-8511

Connecting the power
• Before plugging in the unit, confirm that all connections have been made properly.
• Before turning on the power, be sure that the VOLUME knob is fully turned counterclockwise.
• Turning on this unit’s power may cau.se a momentary power surge, which might interfere with other electrical equipment, such as com¬
puters. If so, use a wall outlet on a different circuit.
U.S. and Canadian models:
Plugging the TX-8511's power cord into an AC outlet puts the
unit in stand-by status (the STAND-BY indicator is lit). Pre.ssing
the POWER switch turns on the unit and lights up the display. If
this switch is pressed again, the unit returns to the stand-by status.
The POWER button on the remote control is u.sed in the same way
as the POWER switch on the TX-8511.
Models other than U..S. and Canadian models:
After plugging the TX-8511 ’s power cord into an AC outlet, press
the SYSTEM switch to put the unit in power-on status (the unit
can be operated and its display is lit). The remote control cannot
be used to operate the TX-8511 if the SYSTEM switch is not set to
ON.
When the SYSTEM switch is set to ON, pressing the POWER but¬
ton on the remote control switches the TX-8511 between stand-by
.status (the STAND-BY indicator is lit) and power-on status (the
display will light up).
Pressing the SYSTEM switch on the TX-8511 to set it to OFF
turns off the unit. (When the SYSTEM switch is set to OFF. only a
small amount of power is used.)
12