Onkyo TX-8511

Entering station names
RF ***sre«o
CFCAMAS A »UHUH » riMD < cno^
Oi SlfACO 0
rii' i L / i .jri Zi
Ul'll' 1 lU l-a.
/ Ih II./ iJI I
Ul 'll' I IU
C
I II' II./1.
UI 'll' I
.11 I
lU
4
l~l I' 11./ </ I I
u I 'll' I u
I II' II./ </1 I
u I 'll ' I u
While receiving :i preset FM or AM station, a maximum of 8
characters consisting of letters, numbers and some symbols
can be stored, for example to represent the station name.
European and some other models only:
If you attempt to enter characters for an FM station broad-
ca.siing RDS information, “KDS...P,S‘’ is displayed and char¬
acters catmot be entered.
Characters which can he entered:
ABCDEFGHIJKLMNOPQRSTU
VWXYZ1234567890-,..*/
•Note; u indicates a space.
As an example, assume an FM station with a frequency of
89.50 MHz has been stored in preset number 2CH of group
B and will be given the name “ONKYO".
1.Select the desired station.
(Refer to Selecting presel .\lations on page 17.)
2.1’ress the CHARACTER button on the front panel.
The frequency in the display goes off and the cursor ( _ )
Hashes.
3.Contiime pressing tlie 5MNO button until “O" is dis¬
played.
With each press of the button, the character that appears
in the display changes one at a time in the following
sequence: 5-»M-»N-^0-» 5...
If a button is not pressed within one second, the cursor
automatically moves to the next position.
■ |b delete a charticier, press the DIRECT TUNING button.
After the .selected character is deleted, all characters to the
right of the deleted character move one space to the left.
d.Continuc pressitig number buttons to enter the desired
characters.
To enter N, pre.ss the 5MNO button.
To enter K, press the 4JKL button.
To enter Y, press the 9YZ- button.
S.Press the CHARACTER button to store the entered
characters.
If a button is not pressed within 16 .seconds, the operation
will end automatically.
• Pre.ss the DISPLAY button when you wish to check the
frequency while you are entering the characters.
; Changing an entered character.- ;
1. Select the desired station.
(Refer to Selecliiig prc.wl .vuilion.'- on page 17.)
2. Pre.ss the CHARACTER button.
The first character and the cursor Hash alternately.
3. Pre.ss the ◄ DOWN or UP ► TUNING button to move
the cursor below thelcharacter that you wish to change.
The cursor moves to the right when the UP ► button is
pressed and moves to the left when the ◄ DOWN button
is pressed.
4. Enter the desired character.
The previous character is replaced with a new character.
5. Press the CHARACTER button.
Cleariitg all characters
1. Select the desired station.
(Refer to Selfciing preset stations on page 17.)
2. Press the CHARACTER button.
3. Hold down the MEMORY button and press the E.M
MUTE/MOUE button.
All characters entered for the selected station are cleared.
4. Press the CHARACTER button one more time.
20