Onkyo TX-8511

Recording a source
2
vneo-livop vioea:yKA TAPetwoMron tak-i
Recording an audld^burce ^
Pleasi; read the instniciion manuals con¬
cerning the operation of each unit.
1. Insert a blank tape into the tape deck.
2. Press the button (other tlian TAPE-2
MONITOR) of the source from
which you want to record.
• When VIDEO-IA'DP or VIDEO-2/
VCR is selected, it wall (naturally) only
record the audio.
• When FM or AM is .selected, set the
tuner to the station you want to record
frotn.
• When TAPE-1 is .selected, it will record
to the TAPE-2.
• When either VIDEO-l/VDP, VIDEO-
2/VCR, FM, AM. PHONO or CD is
selected, you are able to record to both
the TAPE-1 and TAPE-2.
3. Put the tape deck in the recording
mode. Begin playing the source.
.Set the proper recording level using the
controls on the tape deck used for record¬
ing. Al.so, during recording and dubbing
o|)erations, if any controls (bass, treble
etc.) on this unit are changed during
recording and dubbing operations, the tone
effects will not change.
NOTE;
Recording from TAPE-2 to TAPE-1 is not
possible.
Tape-to-Tape Dubbing
1. Loitd the origintil tape in TAPE-1
tape deck and the blank tape in
TAPE-2 tape deck.
2. Pre.ss the TAPE-1 button.
3. Put TAPE-1 tape deck in the play¬
back mode and TAPE-2 tape deck in
recording mode.
2
TAre-l
21