Onkyo TX-8511

Receiving stations
1
2
2 1
■ ( ■ / /
I I
I II I
rWMUrt • tUNU* «
OM UttlilU
CROUP
L. t‘'l
1 1 1
oo nn
_//_/. uu^
Ch
• lUMU « CHAP*
Oi''i
1 II 1
1 D c n
IL. UU-~
O*
Please make sure that the I T-2 MONITOR |
anil AUDIO MUTE indicators are not lit.
; : Tuning the radio (Manual
[Tuning and|Direct'tunln^
When the frequency i.s not known (Man¬
ual tuniii}’)
1. I’res.s the F.M or A.M button.
2. Use the ◄ DOWN TUNING UP ►
buttons to cbange the frequency.
UP.the frequency increases.
DOWN t he frequency decreases.
• The frequency is changed in 100 kHz
(or 50 kHz) steps in FM and 10 kHz (or
9kHz) in AM each time a tuning selec¬
tor button is pressed.
• If a button is held continuously for
more than 0.5 seconds, the frequencies
are scanned automatically. (FM auto
tuning mode)
When it broadcast is received, scanning
stops.
I I I
1 2 3
FU AM
2
(WCCT TUNINQ
L. h'l
I I I
I MtC Z J IM"
t &fU ■ «WI •
)w Willi • rutilu 4
UN SlilAU
lilKJU'
*
G l‘'l
1 1 1
o o
UUf-'- „„ Ch
o
fwwuti
ON sti««o
QMJUP
A
G /'W
1 1 1
O O 11~l
UU. lU^ CM
When the frequency is known (Direct
tuning)
1. i’ress the FM or AM button.
2. Press the DIRECT TUNING button.
The will Dash for 16 .seconds in
the frequency display.
.5. luilcr the fre(|uency with tlie number
buttons while the cursors are flasb-
ing.
Example; 88.10 MHz 8 -> 8 0/10
• When receiving AM broadcasts with a
9 kHz step (this depends on your
region), you can enter the frequency
directly.
With 10 kHz steps, entering a number
for the 10 kHz digit will .set the 1 kHz
digit automatically to 0.
• If you enter a frequency that is out of
range, this unit will return to the previ¬
ous frequency. If this happens, repeat
the procedure.