Onkyo TX-8511

R0C6iving RDS (Only for European and some other models)
DISPLAY SCAN PTY/TP
o
- ^ '1
—.—-^
lo
s—(Lr-U-i"!
O 1
© 1 1 i 1 i 1 1 f 1
O O O
xzj ^ y—J
DOWN TUNING UP ►
1 PIXIP
‘ V\ _
X \ L. Ul lU 1
V ' -II Ul' 1
0 — ooyw TU»*MG UP ^
y
1 LJI II /./ I-'I
O SCAN
A UCUi
^ C53
4 punp
T t.J
l !
O SC*H
\
■ TTipi . . ' —; -
Searchlngdor a station which broadcasts^youry -i
favorite category (PTY scan).,. ■ (j f
1. Press the P'l'Y/TP hiittun, and the pniEram type of the cur¬
rently selected station will he shown on the display (for
example, “SPORT”).
If the station you arc receiving is not broadcasting RDS, “NOT
RDS” (tills is not an RDS station) will be shown on the display.
2. Use the 'I’UNING UP/DOVVN buttons to select another pro¬
gram type (Fl'Y) (for example, “ROCK M”).
See the PTY descriptions on the previous page.
3. Press the SCAN button to start searching for the chosen
Fl'Y station.
When a station is received with the desired I’TY, the .scanning
stops for approximately 5 seconds, before the unit starts scan¬
ning .again.
4. When the desired station is reached, press SCAN button
again to stop scanning.
Receiving RDS traffic Information
If the station you are listening to is not an RDS station, this func-
tiim cannot be used.
1. Pre.ss the PTY/TP button until “Tl’” appears on the dis-
play.
If : T P z is shown on the display, it indicates Uiat the current
.station is broadcasting irafnc inforination. ,
2. Pre.ss the SCAN button to start searching for a TP station.
When the unit receives a TP station, it stops .scanning.
If the unit cannot receive any signal. “NOT FIND” (cannot find
the station) is shown on the display.
1
r-^ Frequency -» Characler or Program
Service Name
-Radio Texl --
If the .station you are listening to is not an RDS station, this func¬
tion cannot be used.
1. Each time you press the DISPLAY button, the display
changes as shown in the left.
If the current station you arc listening to is not an RDS station,
only the frequency of the station or the station name, if you have
entered it (see page 20) appears. (If there have been no characters
entered, only the frequency is shown.)
When RT is received, it can sometimes take between a lew seconds
aitd 15 secomis (more or less) to show RT on the display.
Sometimes the following mc.ssages will be shown on the display.
WAIT: indicates that it requires more lime to receive the RT
infonnation. When the information is received, the characters will
.scroll across the display.
NO TEXT: this appears for 3 seconds and indicates that even
though an RDS station is being received, there is no RT informa¬
tion included.