89
Zone 2—Continued
Controlling Zone 2 with the Remote
Controller
Note:
• To control Zone 2, you must press the remote control-
ler’s [ZONE 2] button first.
Adjusting the Volume for Zone 2
To Mute Zone 2 :
Press the remote controller’s [ZONE 2] button, followed
by the [MUTING] button. To unmute Zone 2, press the
remote controller’s [ZONE 2] button again, followed by
the [MUTING] button, or adjust the volume for Zone 2.
Notes:
• Only analog input sources are output by the ZONE 2
LINE OUT and ZONE 2 SPEAKERS terminals. Dig-
ital input sources are not output. If no sound is heard
when an input source is selected, check if it’s con-
nected to an analog input.
• While Zone 2 is being used, listening modes that need
surround back speakers (i.e., Dolby Digital EX and
DTS-ES) are unavailable.
• While Zone 2 is on, functions will not work.
• You can’t select different radio stations for Zone 2 and
the main room. For example, if you have an FM sta-
tion for the main room, that station will also be used in
Zone 2.
1
Press the [ZONE 2] button, then
point the remote controller at the
AV receiver/AV amplifier and
press the [STANDBY/ON] button.
Zone 2 turns on and ZONE 2 indicator
lights up.
2
To select an input source for
Zone 2, press the [ZONE 2] but-
ton, followed by an INPUT
SELECTOR button.
To select AM or FM press the
[TUNER] INPUT SELECTOR button
repeatedly.
3
To turn off Zone 2, press the
[ZONE 2] button, followed by the
[STANDBY/ON] button.
ZONE 2
LEVEL –/+
INPUT
SELECTOR
TANDBY/ON
On the remote controller, press
the [ZONE 2] button, and then
use the [LEVEL–] and [LEVEL+]
buttons.
On the AV receiver/AV amplifier,
use the ZONE 2 LEVEL [ ]/[ ]
buttons.
If your Zone 2 speakers are connected
to an amp in Zone 2, use its volume
control to adjust the volume.
ZONE 2 LEVEL ,
Remote
controller
AV receiver/
AV amplifier
To Next Page
Loading...
