Lift the exterior safety catch and raise the
bonnet.
Unclip the bonnet support from its
housing and place it in the support slot
to hold the bonnet open.
Closing
Hold the bonnet and pull out the bonnet
support from the support slot.
Clip the bonnet support in its housing.
Lower the bonnet and let it fall into the
latch from a low height (20-25 cm).
Caution
Do not press the bonnet into the latch
to avoid dents.
Check that the bonnet is engaged.
Caution
Because of the presence of electric
equipment under the bonnet, it is
strongly recommended that exposure to
water (rain, washing, etc.) be limited.
Caution
Do not press the bonnet into the latch
to avoid dents.
ENGINE OIL
Check the engine oil level manually
on a regular basis to prevent damage
to the engine. Ensure that the correct
specification of engine oil is used.
Recommended fluids and lubricants ð
page 170.
The maximum engine oil consumption is
0.6 l per 1000 km.
Check with the vehicle on a level
surface. The engine must be at operating
temperature and switched off for at least
five minutes.
Pull out the dipstick, wipe it clean,
reinsert it fully, pull out and read the
engine oil level.
Different dipsticks are used depending on
engine variant.
Warning
Insert dipstick fully up to the stop on the
handle.
Ensure that no engine oil gets into the
engine compartment, as this increases
risk of fire.
When the engine oil level has dropped to
the MIN mark, top up the engine oil. We
recommend the use of the same grade
of engine oil that was used at last oil
change.
Vehicle care 147
To Next Page
Loading...
