Bulb replacement
Before replacing a bulb, ensure that all
exterior and interior lights and the ignition
are switched off.
Only hold a new bulb at the base. Do not
touch the bulb glass with bare hands.
Use only the same bulb type for
replacement.
Bulb check
Switch on the ignition, operate and check
the lights.
LIGHT-EMITTING DIODE (LED)
HEADLIGHTS AND LIGHTS
Headlights for low and high beam,
daytime running lights and turn lights
are designed as LEDs and cannot be
changed.
Have lights repaired by a workshop in
case of failure.
FRONT FOG LIGHTS
Fog lights are designed as LEDs.
Have the lights repaired by a workshop in
case of failure.
R
EAR FOG LIGHTS
Fog lights are designed as LEDs.
Have the lights repaired by a workshop in
case of failure.
TAIL LIGHTS
LED Tail lights
Have lights repaired by a workshop in
case of failure.
Tail light assembly
1.
Open the tailgate then unclip the
access cover on the relevant side.
2.
Carefully detach the plug from the
retainer.
Turn the three screws anticlockwise
and take them out.
Remove the bulb carrier from the tail
light assembly.
152 Vehicle care