The engine oil level must not exceed the
MAX mark on the dipstick.
Caution
Overfilled engine oil must be drained or
suctioned out. If the engine oil exceeds
the maximum level, do not start the
vehicle and contact a workshop.
Fit the cap on straight and tighten it.
Capacities ð page 176.
ENGINE
COOLANT
The factory filled coolant provides freeze
protection down to approx. -37 °C.
Caution
A too low coolant level can
cause damage to the high voltage
components.
Caution
Only use approved antifreeze.
Coolant and antifreeze ð page 170.
Coolant level BEV
If the coolant level is at the MIN mark
or below, seek the assistance of a
workshop to have the engine coolant
topped up.
Caution
Using the wrong engine coolant can
cause severe damages to the high
voltage battery. Only experienced
mechanics are allowed to open the
coolant reservoir and to top up coolant.
Propulsion types ð page 3
Coolant level ICE and Hybrid
48 V
If the cooling system is cold, the coolant
level should be above the MIN mark. Top
up if the level is low.
Warning
Allow the engine to cool before opening
the cap. Carefully open the cap,
relieving the pressure slowly.
To top up, use a 1:1 mixture of released
coolant concentrate mixed with clean
tap water. If no coolant concentrate is
available, use clean tap water. Install the
cap tightly.
Have the coolant concentration checked
and have the cause of the coolant loss
remedied by a workshop.
148 Vehicle care
To Next Page
Loading...
