device must be placed between the
positioning aids.
On some mobile devices, a back cover
with an integrated coil or a jacket may be
required to use inductive charging.
A protective cover for the mobile device
could have impact on the inductive
charging.
In the event that the mobile device is
not charging properly, rotate it 180° and
place it on the charging device again.
Status LED
The LED indicates the current charging
status.
Illuminates green
The mobile device is charging.
Flashes yellow
The mobile device has not been centred
properly in the charging zone or an
unknown object has been detected in the
charging zone.
Illuminates yellow
There is a problem with the mobile
device's battery or a fault of the inductive
charger has been detected.
If the problem persists, seek the
assistance of a workshop.
12 V power outlet
Plug in a 12 V accessory (with a
maximum rated power of 120 W) using
a suitable adapter.
Observe the maximum power rating to
avoid damaging the accessory.
Do not exceed the maximum power
consumption of 120 W.
The 12 V power outlet is deactivated in
the event of low vehicle battery voltage.
Electrical accessories that are connected
must comply with the electromagnetic
compatibility requirements laid down in
DIN VDE 40 839.
Do not connect any current-delivering
accessories, e.g. electrical charging
devices or batteries.
Do not damage the outlet by using
unsuitable plugs.
USB Port
These symbols determine the type of use
of a USB socket:
Power supply and recharging.
To connect a portable device to
the Infotainment system, use this
port
Likewise, plus use of smartphone
applications with the touch screen.
58 Dashboard Instruments And Controls
To Next Page
Loading...
