Control buttons
SOS button
In an emergency situation press and
hold SOS button for more than two
seconds.The green LED and the voice
message will confirm that the call has
been sent to the emergency centre.
The green LED illuminates when the
service connection is established. It will
extinguishes when the connection is
complete.
A minimum set of data is transferred
to the emergency centre, including such
data as car location, car model, vehicle
identification number. The operator will
contact you and, if necessary, send
rescue workers from the relevant support
services.
To cancel the call, press the SOS button
again. The green LED extinguishes. The
voice message confirms the cancellation.
Status LED
The system provides feedback via voice
messages and an LED.
Green
: The system is activated. A
connection to an operator is
on duty.
Red : The system is booting
up after switching on
the ignition, the LED
extinguishes after 3 seconds.
If the LED stays red,
a malfunction has been
detected in the system. An
emergency call may not
work. Contact a workshop
immediately.
Red
flashing
: The internal backup battery
is defective.
Contact a workshop
immediately.
Seek the assistance of a workshop if the
LED does not illuminate after switching
on the ignition.
Dashboard Instruments And Controls 63
To Next Page
Loading...
