3.
Remove and replace the bulbs:
1 Position light / Stop light
2 Position light
3 Turn light
4 Reverse light
4. Insert the bulb carrier into the tail light
assembly.
Insert the three screws and turn them
clockwise.
Attach the plug to the light assembly.
Attach the cover.
CENTRE HIGH-MOUNTED BRAKE
LIGHT
Have lights repaired by a workshop in
case of failure.
N
UMBER PLATE LIGHT
● Insert a screwdriver in the recess of the
cover and remove it.
● Pull the bulb from the bulb holder and
replace it.
● Attach the cover.
INTERIOR LIGHTS
Have the following bulbs replaced by a
workshop:
●
courtesy light, reading lights
●
load compartment light
●
instrument cluster illumination
Electric system
FUSES
A defective fuse must be replaced by a
workshop.
Vehicle tools
Depending on version the vehicle tools
are located in a toolbag in the load
compartment either behind the third row
or below the floor cover.
1 - Jack
2 - Wheel wrench
3 - Towing eye
4 - Wheel bolt cover remover
5 - Chock
Vehicle care 153
To Next Page
Loading...
