increased. This will be achieved by an
idle boost which may be audible.
A message appears on the cluster.
Power outlet
The power outlets are deactivated in the
event of low vehicle battery voltage.
Power saving mode
This mode deactivates electrical
consumers to avoid excessive
discharging of the vehicle battery.
These consumers, such as the
Infotainment system, windscreen wipers,
low beam headlights, courtesy light, etc.
can be used for a total maximum time
of about 40 minutes after ignition is
switched off.
Changing into power saving mode
When power saving mode is activated, a
message appears on the cluster, when
the ignition has been switched off.
An active telephone call using the hands-
free option will be maintained for around
ten minutes longer.
Deactivating power saving mode
Power saving mode is deactivated
automatically when the engine is
restarted. Run the engine for a sufficient
charge:
● for less than ten minutes to use the
consumers for approx. 5 minutes
● for more than ten minutes to use
the consumers for up to approx. 30
minutes
Heating functionalities
Note
Individual heating functionalities, such as
heated seats or heated steering wheel,
may be temporarily unavailable in the
event of electric loading constraints.
Functions will be resumed after some
minutes.
WIPER BLADE REPLACEMENT
Windscreen
Switch off ignition.
Within one minute after switching off
ignition, operate the wiper lever to
positon the wiper blades vertically on the
windscreen.
Lift the wiper arm until it stays in
the raised position, press button to
disengage the wiper blade and remove.
Attach the new wiper blade to the wiper
arm and push until it engages.
Lower wiper arm carefully.
Rear window
Lift wiper arm. Disengage wiper blade as
shown in illustration and remove.
Attach the wiper blade slightly angled to
the wiper arm and push until it engages.
Lower wiper arm carefully.
Vehicle care 151
To Next Page
Loading...
