Clean seat belts with lukewarm water or
interior cleaner.
Caution
Close Velcro fasteners as open Velcro
fasteners on clothing could damage
seat upholstery.
The same applies to clothing with
sharp-edged objects, like zips or belts
or studded jeans.
Plastic and rubber parts
Plastic and rubber parts can be cleaned
with the same cleaner as used to
clean the body. Use interior cleaner if
necessary. Do not use any other agent.
Avoid solvents and petrol in particular.
Do not use highpressure jet cleaners.
FLOOR MATS
Warning
If a floor mat has the wrong size
or is not properly installed, it can
interfere with pedals, what can cause
unintended acceleration or increased
stopping distance which can cause a
crash and injury.
Use the following guidelines for proper
floor mat usage.
●
The original equipment floor mats
were designed for this vehicle. If the
floor mats need to be replaced, it
is recommended to buy certified floor
mats which fit properly and are fixed
by the retainers on the driver side.
Always check that the floor mats do not
interfere with the pedals.
● Use the floor mat with the correct side
up. Do not turn it over.
● Do not place anything on top of the
driver's side floor mat.
● Use only a single floor mat on the
driver's side.
Installing and removing the
floor mats
The driver's side floor mat is held in place
by two retainers.
To install the floor mat:
1. Move the seat backwards as far as
possible.
2. Align slots in the mat with the
retainers, as shown.
3. Push the mat to the floor.
To remove the floor mat:
1. Move the seat backwards as far as
possible.
2. Pull the floor mat upwards to remove.
168 Vehicle care
To Next Page
Loading...
