Opsis LD500 - Page 4

7.1.2 Demultiplexers, MXn01L .............................................................................28
7.2 Switching multiplexers, SX10nL .................................................................28
7.2.1 Technical specification .................................................................................29
7.2.2 The DIP switches ..........................................................................................29
7.2.3 RS232 port configuration .............................................................................30
7.2.4 Software configuration .................................................................................30
7.2.5 Function test of the switch ............................................................................31
7.2.5.1 The function LED´s ......................................................................................31
8 Maintenance ................................................................................................33
8.1 Check list for preventive maintenance .........................................................33
8.2 Emitter and receiver .....................................................................................34
8.2.1 Cleaning the mirrors and windows ...............................................................34
8.3 Autocalibration units ....................................................................................34
9 Installation drawings ..................................................................................35
A Appendix: ER060AUTOL setup ..................................................................i
A.1 Enter the IO256 software .................................................................................i
A.2 Communication units using the IOMan protocol ............................................i
A.3 Load the settings from the IOMan modules ...................................................ii
A.4 Logg the calibration cell temperature .............................................................ii
A.5 Configuration of the CU007 ...........................................................................ii