Optoma EP783 - Chapter 2 Disassembly Process; Equipment Needed & Product Overview

EP783/EP783S/EP783L/OPX5000/TX783L/TX783S
Condential
2-1
Chapter 2
Disassembly Process
2-1 Equipment Needed & Product Overview
1. Screw Bit (+) :105
2. Screw Bit (+) :107
3. Screw Bit (-) :107
4. Hex Sleeves 5 mm
5. Tweezers
6. Projector
* Before you start: This process is protective level II. Operators should wear electrostatic chains.
* Note: - If you need to replace the main board, you have to get into service mode and record the
lamp usage hour.
- As the disassembliy process of EP783/EP783S/EP783L/OPX5000/TX783L/TX783S is the
same, we take EP783 for example here.