Optoma HD710 - Chapter 2 Disassembly Process; Equipment Needed & Product Overview

HD71/HD710/HD75 Condential
2-1
Chapter 2
Disassembly Process
2-1 Equipment Needed & Product Overview
1. Screw Bit (-) :107
2. Screw Bit (+) :107
3. Hex Sleeves 5 mm
4. Hex Sleeves 8 mm
5. Tweezers
6. HD71/HD710/HD75 unit
* Before you start: This process is protective level II. Operators should wear electrostatic chains.
* Note: 1. If you need to replace the main board, you have to get into service mode and record the
lamp usage hour.
2. Take HD71 as an example, HD710/HD75 is the same with HD71