Optoma L1 - Input Menu

English
41
USING THE PROJECTOR
Input menu
Input auto source menu
Choose this option to let the projector automatically nd an available input source.
Input remember last source menu
Choose this option to always start the projector with the last input source.
Input auto input switch menu
When HDMI input signal is detected, the projector will automatically switch the input source.
Input HDMI CEC settings menu
Note: When you connect HDMI CEC-compatible devices to the projector with HDMI cables, you can control them
on the same power on or power o status using the HDMI Link control feature in the projector’s OSD. This
lets one device or multiple devices in a group power on or power o via HDMI Link Feature in a typical
conguration, your DVD player may be connected to the projector through an amplier or home theater
system.
HDMI
Amplier
HDMI
DVD Player
HDMI Link
Enable/disable the HDMI Link function.
Inclusive of TV
If the settings is set to “Yes” then the power on and power o󰀨 link options are available.
Power On Link
CEC power on command.
 Mutual: Both projector and CEC device will be turned on simultaneously.
 PJ  Device: The CEC device will be turned on only after the projector is switched on.
 Device  PJ: The projector will be switched on only after the CEC device is turned on.
Power O󰀨 Link
Enable this function to let both HDMI Link and projector to be automatically turned o󰀨 at the same time.
Input reset menu
Return the factory default settings for input settings.