Optoma L1 - Powering Projector On;Off; Powering On Procedure; Powering Off Procedure

English
25
USING THE PROJECTOR
Powering on / o󰀨 the projector
Enter
or
Enter
Powering on
1. Securely connect the power lead and signal/source cable. When connected, the On/Standby LED will
turn red.
2. Turn on the projector by pressing the “ ” button on the projector keypad or the remote control.
3. A start up screen will display in approximately 1 second and the On/Standby LED will be ashing
white.
Note: The rst time the projector is turned on, you will be prompted to select the preferred language, projection
orientation, and other settings.
Powering o󰀨
1. Turn o󰀨 the projector by pressing the “ ” button on the projector keypad or the remote control.
2. The following message will be displayed:
Power O󰀨
Power O󰀨?
Press power key again.