Optoma L1 User Manual

English
23
SETUP AND INSTALLATION
Remote setup
Installing / replacing the battery
1. Press the lock button next to the battery compartment cover.
3
V
O
L
T
S
CR2032
2. Use a coin to turn the battery cover counterclockwise until the cover opens.
3. Install new battery into the compartment.
Remove the old battery and install new one (CR2032). Ensure that the side with a “+” is facing up.
4. Put the cover back. Then use a coin to turn the battery cover clockwise to lock it in place.
3
V
O
L
T
S
CR2032
3
V
O
L
T
S
CR2032
CAUTION:
To ensure safe operation, please observe the following precautions:
 Use CR2032 type battery.
 Avoid contact with water or liquid.
 Do not expose the remote control to moisture or heat.
 Do not drop the remote control.
 If the battery has leaked in the remote control, carefully wipe the case clean and install new battery.
 Risk of an explosion if battery is replaced by an incorrect type.
 Dispose of used battery according to the instructions.
Warning: Do not ingest battery, Chemical Burn Hazard.
 This product contains a coin / button cell battery. If the coin / button cell battery is
swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
Warning: Keep new and used batteries away from children.
 If the battery compartment does not close securely, stop using the product and keep it
away from children.If you think batteries might have been swallowed or placed inside any
part of the body, seek immediate medical attention.

Optoma L1 Specifications

General

Number of colors	1.073 billion colors
Native aspect ratio	16:9
Projection distance	0.47 - 0.74 m
Vertical scan range	50 - 240 Hz
Projection technology	DLP
Contrast ratio (typical)	1800000:1
Screen size compatibility	75 - 120 \
Projector native resolution	2160p (3840x2160)
Keystone correction, horizontal	10 °
Projector brightness (economic mode)	1050 ANSI lumens
Lamps quantity	1 lamp(s)
Light source type	LED
Service life of light source	30000 h
Focus	Auto/Manual
Offset	126 %
Throw ratio	0.25:1
Fixed focal length	2.63 mm
Analog signal format system	-
DVI port	No
Audio (L/R) out	1
HDMI connector type	Full-size
HDMI ports quantity	3
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
VGA (D-Sub) ports quantity	0
Noise level	28 dB
Preset modes	Game
Number of OSD languages	25
On Screen Display (OSD) languages	ARA, CHI (SIMPL), CHI (TR), CZE, DAN, DEU, DUT, ENG, ESP, FAS, FIN, FRE, GRE, HUN, IND, ITA, JPN, NOR, POL, POR, RUM, RUS, SWE, TUR, VIE
RMS rated power	20 W
Number of built-in speakers	2
Placement	Desktop
Product type	Ultra short throw projector
Product color	Black
Market positioning	Home cinema
Cable lock slot type	Kensington
Power source	AC
AC input voltage	100-240 V
AC input frequency	50-60 Hz
Power consumption (max)	165 W
Power consumption (standby)	0.5 W
Power consumption (typical)	98 W
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 80 %

Weight and Dimensions

Depth	316 mm
Width	400 mm
Height	102.3 mm
Weight	5100 g
Package weight	7800 g