Optoma L1 - LED Lightning Messages

English
54
ADDITIONAL INFORMATION
LED lightning messages
Message
On/Standby LED Temp LED Lamp LED
(Red) (White) (Red) (Red)
Standby state
(Input power cord)
Steady light
Power on (Warming)
Flashing
(0.5 sec o󰀨 / 0.5 sec on)
Power on and Lamp Steady light
Power o󰀨 (Cooling)
Flashing
(0.5 sec o󰀨 / 0.5
sec on). Back to red
steady light when
cooling fan turns o󰀨.
Quick resume (100ms)
Flashing
(0.25 sec o󰀨 / 0.25 sec
on)
Error (Lamp failure) Flashing Steady light
Error (Fan failure) Flashing Flashing
Error (Over temp.) Flashing Steady light
 Power o󰀨:
Power O󰀨
Press power key again.
 Temperature warning:
Warning
TEMPERATURE TOO HIGH
Please:
1. Make sure air in and outlets are not blocked.
2. Make sure the environment temperature is under 45 degree C.
If the problem persists in spite of the above.
Please contact a service center for repair.