Optoma PS200 - Input Config; Analog Inputs; VGA Setup

© Optoma
Issue 2.1 July 25, 2018
34
6.1.2 Input Config
6.1.2.1 Analog Inputs
6.1.2.1.1 VGA Setup
 Clock\Phase
Frequency (Clock) and phase can also be altered manually, as the vertical and horizontal position
Settings: 0 to 32
Default : 0
 Colour Space
Settings: RGB or YCbCr
Default: RGB
 Range
The greyscale range can be reduced by switching from full to limited (see range values discussed
in the output config section)
Settings: Full / Limited
Default: Full
 Reset Mode
A reset button to factory defaults is provided, to return the phase, clock and positional settings to
the original positions.
 EDID IN
The preferred video mode can be selected in the EDID Input Format menu. This setting can force
the source to output a certain video mode provided the driver of the graphic card reads the
preferred timing in the EDID. Most likely the PC needs to be rebooted for the driver to notice the
EDID change.
Default: 1920x1080p
 EDID F/R :
The preferred video frame rate can be selected from the provided menu. This setting can force
the source to output the selected frame rate provided the driver of the graphic card takes notice
of the preferred timing in the EDID. The PC most likely has to be rebooted for the driver to take
notice.