© Optoma
Issue 2.1 July 25, 2018
41
6.1.3.4 Saturation
Controls the video colour saturation, (applies individually to all video inputs but not computer input
signals or formats).
Settings: -50 to 50 in steps of 1
Default: 0
6.1.3.5 Hue
Adjusts the colour hue of NTSC signals. This is not applicable for computer input signals or formats.
Settings: -50 to 50 in steps of 1
Default: 0
6.1.3.6 RGB values
This is a user-defined colour temperature setting where R,G,B gain (white balance) and offset/bias
(black balance) can be adjusted separately in order to match the display device.
This control is not available for output modes with colour space format YUV 4:2:0.
Settings: Red/Green/Blue Gain/Bias: -512 to 512
Default: 0
6.1.3.7 Colour Temp
A preset range of Colour Temperature allowing the user to select from pre-configured colour
temperatures to match the colour temperature of the incoming signal. If this value Native Colour
Temp value in the Output menu are the same, no conversion is performed.
Settings: 3200K, 3700K, 5500K, 6500K, 7500K, 9300K
Default: 6500K
6.1.3.8 Input Gamma
Set this value to match the gamma of the input signal. Input and output gamma both default to 1.0. If
they are both set to the same value, there is no effect on the image.
Settings: 1.0 to 3.0 in steps of 0.1
Default: 1.0
To Next Page
Loading...
