Configuring System Security Settings
On the Security tab, configure the settings as described in the following table:
Table 9-1 BIOS Security Settings
Setting Description of Option
Secure Boot Configuration Disabled by default. To enable, set the
Supervisor Password.
Secure Boot Option Enable or Disable the UEFI secure boot
firmware validation process.
Reset to Default Reset secure boot variables to the factory
default.
Change to Customization Delete the protection key, change the platform
to setup mode, and disable secure boot.
Set Supervisor Password Set or clear the supervisor password.
Supervisor Hint String Enter a hint for the password.
Min. Password Length Set a minimum length to enforce for user
passwords.
HDD Password Select Select the password structure to apply to hard
disk drives:
• User Only: Supports user account
passwords.
• User + Master: Supports user account
passwords and a master password.
Set HDDNumber User Password Set a password for the user account for this
HDD.
Set HDDNumber Master Password Set a master password for this HDD.
TPM Support Enable or Disable Trusted Platform Module
support.
By default, TPM Support is disabled.
Chapter 9
Configuring System Security Settings
9-2
To Next Page
Loading...
Need help?
General
