Oracle MICROS Express Station 4 Series User Manual

9
BIOS Configuration
This section describes how to enter the BIOS System Configuration Utility and how to
configure the system BIOS.
The Oracle MICROS Express Station 4 Series ships with the BIOS pre-configured for
optimal performance. In most cases you will not need to change settings.
Starting the BIOS System Configuration Utility
To configure the BIOS, start the BIOS System Configuration Utility using the following
steps:
1. Connect a USB keyboard to the Express Station.
2. Power on or restart the Express Station.
3. Press F2 immediately after pressing the power button. Continue pressing F2 until
you hear a beep or until the BIOS home screen appears. For touch-capable
Express Stations, you can tap a finger on the bottom left or right corner of the
bootup screen until you hear a beep or until the BIOS home screen appears.
If the Express Station boots into the operating system without starting the utility,
restart the Express Station and try again.
Viewing System Information
On the BIOS Home screen, tap Main, and then tap System Information.
The following is an example set of information presented by the BIOS system
information screen. The actual data shown by your system may vary:
• BIOS Version: 0.0.0.P.404 X64
• Build Time: 02/06/2020
• SMBIOS Version: 03.01
• Processor Type: Intel(R) Celeron(R) CPU 4305UE @ 2.00GHz
• Processor Speed: 2.000 GHz
• System Memory Speed: 2133 MHz
• L2 Cache RAM: 512 KB
• Total Memory: 8192 MB
• Memory Device [0]: Not installed
• Memory Device [1]: 8192 MB (DDR4–2133) @ ChannelB-DIMM0
9-1

Oracle MICROS Express Station 4 Series Specifications

General

Brand	Oracle
Model	MICROS Express Station 4 Series
Category	Touch terminals
Language	English