Oriental motor BLE Series - 6.5 Installing Hollow Shaft Gearheads (Rear Mount)

Installation
−
15
−

Using the rear side as the mounting surface
Safety cover
Safety cover
mounting screw (M3)
Hexagonal socket head screw
Flat washer
Hexagonal nut
Mounting plate
Spring washer
• Mounting hole dimension
E
4×ØC
ØD or more
ØA
Mounting hole dimensions [Unit: mm (in.)]
Model ØA ØBH8 ØC ØD E
BLE23
70 (2.76)
34
+ 0.039
0
(1.34
+ 0.0015
0
)
5.5 (0.22) 25 (0.98) 29 (1.14)
BLE46
94 (3.70)
38
+ 0.039
0
(1.50
+ 0.0015
0
)
6.5 (0.26) 30 (1.18) 39 (1.54)
BLE512
104 (4.09)
50
+ 0.039
0
(1.97
+ 0.0015
0
)
8.5 (0.33) 35 (1.38) 44 (1.73)
Note When installing the gearhead by using its rear side as the mounting surface, prevent contact
between the mounting plate and motor by keeping dimension E below the specied value.