Oriental motor BLE Series - 4 System Configuration

System conguration
−
7
−
4 System conguration
An example of system conguration using the
BLE
Series electromagnetic brake type is shown below.
Driver
Motor
Connection
cable
(supplied or
accessory)
Motor signal
connector
Electromagnetic
brake
connector
Motor power
connector
External control
equipment
Connect I/O signals.
Power supply
Make sure power
supply voltage does
not exceed the rated
voltage.
External
potentiometer
(supplied)
Connect this to set the
motor speed externally.
External DC voltage
Connect an appropriate
power supply to set
the motor speed using
DC voltage.
Circuit breaker
or
earth leakage
breaker
Always connect
a breaker to protect
the primary circuit.
Regeneration unit
EPRC-400P (accessory)
Use this regeneration unit
when using the motor in
operation such as vertical
drive (gravitational operation)
or a large inertial load drive.
Or
Or
Data setter OPX-2A
(accessory)
Support software
MEXE02
Mains filter
Use an AC line filter to
eliminate noise. It effectively
reduces noise generated from
the power source or driver.