Oriental motor BLE Series - 1 Introduction; Product Overview and Standards; Installation Conditions; Safety and Compliance Directives

Introduction
−
2
−
1 Introduction

Before use
Only qualied personnel should work with the product. Use the product correctly after thoroughly reading the section
“2 Safety precautions” on p.4. In addition, be sure to observe the contents described in warning, caution, and note in
this manual.
The product described in this manual has been designed and manufactured to be incorporated in general industrial
equipment. Do not use it for any other purpose. Oriental Motor will not be liable for whatever damage arises from
failure to observe this warning.

Product overview
The
BLE
Series is a line of units, each consisting of a compact, high-torque brushless motor and a high-functional
box-type driver.
Each unit has a
FBL
Ⅱ
compatible mode, so existing users of
FBL
Ⅱ
Series units can use the
BLE
Series units with the
same settings.
With the accessory data setter
OPX-2A
(sold separately) or support software
MEXE02
, you can improve the
performance and set operation data/ parameters and motor operations with ease.

Standards and CE Marking
This product is recognized by UL. The CE Marking (Low Voltage Directive and EMC Directive) is afxed to the
product in accordance with EN Standards.
The name of products certied to conform with relevant standards are represented by applicable unit model motor and
driver part numbers.
z
Applicable Standards
Applicable Standards Certication Body Standards File No. CE Marking
Motor
*
UL 1004-1
CSA C22.2 No.100
UL E335369
Low Voltage Directive
EMC Directive
EN 60034-1
EN 60034-5
EN 60664-1
EN 60950-1
Conform to EN Standards
Driver
UL 508C
CSA C22.2 No.274
UL E171462
EN 60950-1
EN 61800-5-1
Conform to EN Standards
*
Thermal class UL/CSA Standards: 105(A), EN Standards: 120(E)
A temperature test has been conducted with a radiation plate. The size, thickness and material of the radiation plates
are as below table.
Model Size [mm (in.)] Thickness [mm (in.)] Material
BLEM23
115×115 (4.53×4.53)
*
5 (0.20) Aluminum
BLEM46
135×135 (5.31×5.31)
BLEM512
165×165 (6.50×6.50)
*
Electromagnetic brake type: 135×135 mm (5.31×5.31 in.)
z
Installation conditions
Motor Driver
Motor is to be used as a component within other
equipment
Overvoltage category:
Ⅲ
*
Pollution degree: 3
Protection against electric shock: Class
Ⅰ
equipment
Motor is to be used as a component within other
equipment
Overvoltage category:
Ⅲ
*
Pollution degree: 2
Protection against electric shock: Class
Ⅰ
equipment
*
Overvoltage category II when EN 60950-1 is applicable.
z
Low Voltage Directive
The product is a type to be incorporated into machinery, so it should be installed within an enclosure.
•
Install the product within the enclosure in order to avoid contact with hands.
•
Be sure to maintain a Protective Earth in case hands should make contact with the product. Securely ground the
Protective Earth Terminals of the motor and driver.