Oriental motor BLE Series - Page 3

Introduction
−
3
−
z
EMC Directive
This product bears the CE mark under the conditions specied in “Example of motor and driver installation and
wiring” on p.24. Be sure to conduct EMC measures with the product assembled in your equipment by referring to “6.11
Installing and wiring in compliance with EMC Directive” on p.23.
Applicable Standards
EMI
Emission Tests
Harmonics Current Test
Voltage Fluctuations Test
EN 55011 group 1 class A
EN 61000-6-4, EN 61800-3 C3
EN 61000-3-2
EN 61000-3-3
EMS Immunity Tests EN 61000-6-2, EN 61800-3 C3
Caution: This equipment is not intended for use in residential environments nor for use on a lowvoltage public
network supplied in residential premises, and it may not provide adequate protection to radio reception
interference in such environments.

UL RECOGNITION OF DRIVER
Drivers are recognized by UL at following condition.
•
Maximum Surrounding Air Temperature 50°C.
•
Install device in pollution degree 2 environment.
•
Solid state motor overload protection reacts at less than 160% FLA.
•
Suitable For Use On A Circuit Capable Of Delivering Not More Than 5,000 Arms Symmetrical Amperes, 120 or
240 VAC Maximum Voltage.
•
Integral solid state short circuit protection does not provide branch circuit protection. Branch circuit protection
must be provided in accordance with the National Electric Code and any additional local codes.
•
Use UL Listed Inverse Time Circuit Breaker rated 120 or 240 VAC, 15 A Only.
•
Drives have no provision for motor over temperature protection. Motor over temperature protection is required at
end application.

RoHS Directive
The products do not contain the substances exceeding the restriction values of RoHS Directive (2011/65/EU).