Oriental motor BLE Series - Load Attachment for Hollow Shaft Gearheads; Using Stepped and Non-Stepped Load Shafts

Installation
−
18
−

Combination type hollow shaft at gearhead
If the motor is subject to a strong impact upon instantaneous stop or receives a large radial load, use a stepped load
shaft.
Note Apply grease (molybdenum disulde grease, etc.) on the surface of the load shaft and inner walls
of the hollow output shaft to prevent seizure.
z
Stepped load shaft
Afxing method using retaining ring
Install each hexagonal socket head screw over a retaining ring, spacer, at washer and spring washer and securely
afx the ring.
ØD
Parallel key
Stepped load shaft
Retaining ring
Spacer
Flat washer
Spring washer
Hexagonal socket head screw
Load shaft
Parallel key
Retaining ring
Spacer
Spring washer
Hollow output shaft Flat washer
Hexagonal
socket
headscrew
Afxing method using end plate
Afx the load shaft by tightening the hexagonal socket head screw over an end plate, at washer and spring washer.
ØD
Parallel key
Parallel key
Stepped load shaft
End plate
End plate
Flat washer
Flat washer
Spring washer
Spring washer
Hexagonal socket head screw
Hexagonal socket
head screw
Load shaft
Hollow output shaft
Note The safety cover (supplied) cannot be attached due to contact between the safety cover and
hexagonal socket head screw. Take safety measures against rotating part.