Installation
−
21
−
Mounting to DIN rail
When mounting the driver to a DIN rail, use a separately sold DIN rail mounting plate (model number:
PADP03
) and
attach it to a 35 mm (1.38 in.) wide DIN rail.
1.
Attach the DIN rail mounting plate (model number:
PADP03
) to the back of the driver using the screws
supplied with the plate.
Tightening torque: 0.3 to 0.4 N·m (2.6 to 3.5 lb-in)
Mounting screws
(supplied)
Mounting holes
(M3, four locations)
DIN rail mounting
plate
2.
Pull the DIN lever down, engage the upper tab of the
DIN rail mounting plate over the DIN rail, and push the
DIN lever until it locks in place.
DIN rail
DIN lever
Tab
3.
Use an end plate (not supplied) to secure the driver.
End plate
z
Removing from DIN rail
Pull the DIN lever down until it locks using a at tip screwdriver, and lift the bottom of
the driver to remove it from the rail.
Use force of about 10 to 20 N (2.2 to 4.5 lb.) to pull the DIN lever to lock it. Excessive
force may damage the DIN lever.
Note
•
Do not use the mounting holes (M3, four locations) for the DIN rail
mounting plate provided in the back of the driver for any purpose
other than securing the DIN rail mounting plate.
•
Be sure to use the supplied screws when securing the DIN rail
mounting plate. The use of screws that would penetrate 3 mm
(0.12 in.) or more through the surface of the driver may cause
damage to the driver.
To Next Page
Loading...