Oriental motor BLE Series - Specific Cautions and Label Information

Safety precautions
−
5
−
•
Do not disassemble or modify the motor (gearhead) and driver. Doing so may result in electric shock, injury or
equipment damage. Should you require inspection or repair of internal parts, please contact the Oriental Motor
branch or sales ofce from which you purchased the product.
Caution
•
Do not use the product in conditions exceeding the motor (gearhead) or driver specications. Doing so may result
in electric shock, re, injury or equipment damage.
•
Do not insert an object into the openings in the driver. Doing so may result in re, electric shock or injury.
•
Do not touch the motor (gearhead) or driver during the operation or immediately after the operation has stopped.
Touching a hot motor (gearhead) or driver surface may cause a skin burn(s).
•
Do not carry the product by the motor (gearhead) output shaft or any of the cables. Doing so may result in injury.
•
Do not place around the motor and driver any object blocking the air ow. Doing so may result in equipment
damage.
•
Do not touch the motor output shaft (key groove or pinion) with bare hands. Doing so may result in injury.
•
When assembling the motor (pinion shaft) with the gearhead, exercise caution not to pinch your ngers or other
parts of your body between the motor and gearhead. Injury may result.
•
Securely afx the motor (gearhead) and driver to their respective mounting plates. Inappropriate installation may
cause the motor/driver to detach and fall, resulting in equipment damage.
•
Provide a cover on the rotating part (output shaft) of the motor (gearhead). Failure to do so may result in injury.
•
When installing the motor (gearhead) in the equipment, exercise caution not to pinch your ngers or other parts of
your body between the equipment and motor or gearhead. Injury may result.
•
Securely install the load on the motor output shaft. Inappropriate installation may result in injury.
•
For the I/O signals power supply, use a DC power supply with reinforced insulation on its primary and secondary
sides. Failure to do so may result in electric shock.
•
Provide an emergency stop device or emergency stop circuit external to the equipment so that the entire equipment
will operate safely in the event of a system failure or malfunction. Failure to do so may result in injury.
•
Immediately when trouble has occurred, stop running and turn off the driver power. Failure to do so may result in
re, electric shock or injury.
•
Do not touch the rotating part (output shaft) during operation. Doing so may result in injury.
•
The motor surface temperature may exceed 70 °C (158 °F) even under normal operating
conditions. If the operator is allowed to approach a running motor, attach a warning label as
shown to the right in a conspicuous position. Failure to do so may result in skin burn(s).
Warning label
•
Use an insulated screwdriver to adjust the internal speed potentiometer, acceleration time potentiometer,
deceleration time potentiometer and switches in the driver. Failure to do so may result in electric shock.
•
Dispose the product correctly in accordance with laws and regulations, or instructions of local governments.

Warning information
A warning label with handling instructions is attached on the driver.
Be sure to observe the instructions on the label when handling the driver.