Oriental motor BLVD20KM - Combination type-hollow shaft flat gearhead

Installation
−17−
[Using a stepped load shaft]
•
Mounting method using retaining ring
Secure the retaining ring to the load shaft by tightening the hexagonal socket head screw over a spacer, at washer
and spring washer.
Flat washer
Spacer
Retaining ring
Stepped load shaft
Pa
rallel key
Spring washer
Hexagonal socket head screw
Retaining ring
Hollow output shaft
Hexagonal socket
head screw
Spring washer
Flat washer
Spacer
Parallel key
Stepped load shaft
ØD
•
Mounting method using end plate
Secure the end plate to the load shaft by tightening the hexagonal socket head screw over a at washer and spring
washer.
Flat washer
End plate
Stepped load shaft
Pa
rallel key
Spring washer
Hexagonal socket head screw
Hollow output shaft
Hexagonal socket
head screw
Spring washer
Flat washer
End plate
Parallel key
Stepped load shaft
ØD
Note
The included safety cover cannot be installed because it interferes against the hexagonal socket head
screws. The customer must provide other protective measure for the rotating part.
[Using a non-stepped load shaft]
Install a spacer on the load shaft side and secure the retaining ring to the load shaft by tightening the hexagonal
socket head screw over a spacer, at washer and spring washer.
Spacer
Retaining ring
Hollow output shaft
Hexagonal socket
head screw
Spring washer
Flat washer
Spacer
Parallel key
Load shaft
Flat washer
Spacer
Retaining ring
Spring washer
Hexagonal socket head screw
Spacer
L
oad shaft
Parallel key