Oriental motor BLVD20KM - 1 Introduction

Introduction
−3−
1 Introduction

Before using the product
Only qualied personnel of electrical and mechanical engineering should work with the product.
Use the product correctly after thoroughly reading the section "2 Safety precautions" on p.4. In addition, be sure
to observe the contents described in warning, caution, and note in this manual.
The product described in this document has been designed and manufactured to be incorporated in general
industrial equipment. Do not use for any other purpose. For the power supply, use a DC power supply with reinforced
insulation on its primary and secondary sides. Oriental Motor Co., Ltd. is not responsible for any damage caused
through failure to observe this warning.

Overview of the product
The
BLV
Series is a motor and driver package combining a slim, high-power brushless motor and a high-performance
box-type driver of DC power input. Using the support software
MEXE02
or data setter
OPX-2A
(sold separately) can
increase the performance, enabling setting of operation data and parameters, and motor operations easily.

Operating manuals for
BLV
Series
For operating manuals not included with the product, contact your nearest Oriental Motor sales oce or download
from Oriental Motor Website Download Page.
Operating manual name Manual number Included or not included with product
OPERATING MANUAL HM-5112 Included
USER MANUAL (Basic Function) HM-5113 Not included
USER MANUAL (RS-485 Communication Mode) HM-5114 Not included
Data setter
OPX-2A
HP-5049 Not included
Network Converter Slave Edition HP-5065 Not included

CE Marking
This product is axed the CE Marking (EMC Directive) based on the EN Standard. The input power supply voltage
of this product is 24 VDC/48 VDC. Therefore this product is not subject to the Low Voltage Directive, but install and
connect it as follows.
•
Installation conditions
To be incorporated in equipment
Overvoltage category:
Ⅰ
Pollution degree: 2
•
EMC Directive
This product has received EMC compliance under the conditions specied in "Example of installation and wiring"
on p.22. The nal level of conformance of your mechanical equipment to the EMC Directive will vary depending
on such factors as the control system equipment used with the motor and driver, conguration of electrical parts,
wiring, layout and hazard level. It therefore must be veried through conducting EMC measures on your mechanical
equipment.
Applicable standards
EMI Emission Tests EN 55011 Group1 Class A, EN 61000-6-4
EMS Immunity Tests EN 61000-6-2
Caution: This equipment is not intended for use in residential environments nor for use on a low-voltage public
network supplied in residential premises, and it may not provide adequate protection to radio reception
interference in such environments.

Republic of Korea, Radio Waves Act
KC Mark is axed to this product under the Radio Waves Act, the republic of Korea.

RoHS Directive
The products do not contain the substances exceeding the restriction values of RoHS Directive (2011/65/EU).