Oriental motor BLVD20KM - 4 System Configuration; Driver

System conguration
−8−
4 System conguration
An example of system conguration using the
BLV
Series electromagnetic brake type is shown below.
Driver
Motor
Connection cable (included)
Motor signal connector
Electromagnetic
brake connector
Motor power connector
External control
equipment
Connect I/O signals.
Power supply
Make sure power supply
voltage does not exceed
the rated voltage.
External potentiometer
（sold separately）
Connec
t this potentiometer
to set the motor speed
externally.
External DC voltage
Connect an appropriate
power supply to set the
motor speed using DC
voltage.
Or
RS-485 communication
Data setter OPX-2A
（sold separately）
Or
PC in which the
support software MEXE02
has been installed
The PC must be supplied by
the user. Use the sold separately
communication cable for the
support software when
connecting the PC and driver.