How to use MEXE02
−50−
3. Click the "CH Settings."
The CH setting window is shown. Set the measurement condition for each CH.
1 Moves the display position of the waveform up and down.
2 Inverts the display of measured signal.
3
Selects the signal to be measured.
The CH1 to CH4 are items for the command speed, load factor, or others. The following types are available.
Command speed (motor output shaft), feedback speed (motor output shaft), inverter voltage, load factor,
selection number
The CH5 to CH12 are items for I/O signals. The following types are available.
ALARM-OUT1, ALARM-OUT2, ALARM-RESET, DIR, EXT-ERROR, FWD(START/STOP), HMI, M0, M1, M2, MB-FREE,
MOVE, MPS, NET-IN0 to NET-IN15, NET-OUT0 to NET-OUT15, REV(RUN/BRAKE), STOP-MODE(FWD/REV), S-BSY,
TLC, VA, WNG, X0 to X5, Y0, Y1
4 Selects a display scale for signals (CH1 to CH4 only). Using this in combination with
⑤
can zoom in on signals.
5
Adds the set oset value to the signal display (CH1 to CH4 only). Using this in combination with
④
can zoom in on
signals.
4. Click "RUN."
Waveform measurement starts.
5. During measurement, click "STOP" to exit the waveform measurement.
If "SINGLE" is selected for Mode in Trigger, measurement automatically ends when the waveform drawing ends.
6. To end the waveform measurement, unselect "Start Waveform Monitor."
10.5 Test operation
Teaching/remote operation
A motor can be operated using the
MEXE02
. The motor operation can be checked before connecting to a
programmable controller.
Also, the teaching function of the operation data can be performed.
Note
•
Teaching/remote operation and I/O test cannot be executed at the same time.
•
While teaching/remote operation is performed, the motor is operated based on the data set in the
teaching data.
If the motor is used in a state where the motor output torque is limited, check the setting of the teaching
data before performing teaching/remote operation.
1. Start the "Teaching, remote operation."
2. Click "Start the teaching remote operation."
1
2
3
4
5
To Next Page
Loading...
