Oriental motor BLVD20KM - Mounting to DIN rail

Installation
−20−

Mounting to DIN rail
Use the DIN rail mounting plate
PADP03
(sold separately) and attach to a 35 mm (1.38 in.) wide DIN rail.
After installation, x the both sides of the driver with the end plate (not included).
DIN rail
DIN lever
Hook
DIN rail mounting
plate
Mounting screw (included)
Tightening torque: 0.3 to 0.4 N·m (2.6 to 3.5 lb-in)
Mounting hole
(M3-4 places)
Note
•
Do not use the mounting holes (M3, four places) for the DIN rail mounting plate for any purpose other
than securing the DIN rail mounting plate.
•
Be sure to use the included screws when securing the DIN rail mounting plate. The use of screws that
would penetrate 3 mm (0.12 in.) or more through the surface of the driver may cause damage to the
driver.
•
Removing from DIN rail
Pull the DIN lever down until it locks using a at tip screwdriver, and lift the bottom of
the driver to remove it from the rail.
Use force of about 10 to 20 N (2.2 to 4.5 lb.) to pull the DIN lever to lock it. Excessive
force may damage the DIN lever.
DIN lever
6.6 Installing an external potentiometer (sold separately)
1. Insert the variable resistor over the insulation sheet into the hole provided in the mounting plate.
2. Set the dial plate and toothed washer, and tighten with the nut.
Tightening torque: 0.45 N·m (3.9 lb-in)
3. Install the dial and secure it with the setscrew (M4).
Tightening torque: 0.4 N·m (3.5 lb-in)
•
Refe
rence mounting hole dimensions
[Unit: mm (in.)]
Ø3 (0.12)
7.5
±0.4 (0.3±0.02)
Ø10 (0.39)
Dial
Nut
Tightening torque:
0.45 N·m (3.9 lb-in)
Toothed washer
Dial plate
Mounting plate
Insulation sheet
Variable resistor
Setscrew
Tightening torque: 0.4 N·m (3.5 lb-in)